Publicité
Les langues disponibles
Les langues disponibles
4.2 Replace Blades
The blade disc automatically changes its rotation direction multiple times during mowing to prevent excessive wear on one side. If the mower is
used on a regular basis, it is recommended to replace the blades and screws every 1–2 months to ensure safety and better mowing results.
Replace all three blades and their screws at the same time for a safe cutting system.
Wet grass is more likely to stick to the blades and the bottom part of the mower, which can affect its performance and require more frequent
cleaning. For optimal results and to maintain your lawn's health, it is best to avoid mowing during heavy rain or when the lawn is excessively
wet.
It is normal for grass clippings to accumulate on the blades during mowing. The design of the blades allows them to continue rotating smoothly
around the screws, even when small amounts of clippings or debris are present. This occasional buildup of clippings should not negatively
impact the mower's ability to effectively cut grass. The mower is designed to perform its function despite minimal clippings collecting on the
blades over time.
While grass clippings can be removed when replacing the blades if desired, immediate action is not required unless an excessive amount of
clippings are stuck on the blades.
WARNING
•
Wear protective gloves when you inspect or service the blade.
•
DO NOT use an electrical screwdriver to install or loosen the blade disc. Only use the right type of screws and original blades as approved by
Navimow. Blade model: HA002E.
•
DO NOT reuse the screws. Doing so can cause serious injury.
How to replace the blades
Turn off the mower.
1
2
To avoid scratching, place the mower on a soft and clean surface in an upside-down position.
Use a cross-tip screwdriver to loosen the three screws.
3
Remove the screws and blades.
4
Publicité
