Segway Navimow i Serie Manuel D'utilisation page 31

2.6.4 Create a VisionFence-off Zone
A VisionFence-off zone is a place where the mower automatically turns off the camera used for obstacle avoidance, so the mower will directly
pass through instead of turning away.
If you need the mower to pass through flat non-grass areas to achieve a thorough cut, you can set up a VisionFence-off zone.
These areas can be, for example, stone roads or utility holes, where the visual detection causes the mower to avoid.
Follow the instructions in the app. You can adjust the size of a VisionFence-off zone, move it to another place, or delete it.
2.6.5 Improve Map Accuracy (optional)
To improve your map accuracy, enable the Camera-assisted Positioning in Settings > MOWER > EFLS 2.0 page.
The Camera-assisted Positioning feature uses the EFLS 2.0 technology to improve positioning accuracy. This means the camera sensor is used
to collect visual elements to form a map that compensates the loss of GPS signal in certain areas.After you finish creating or editing a map,
you can use this feature to correct map inaccuracy due to poor GPS signal during mapping. This improves the map quality and avoids leaving
grass uncut or the mower going out of boundaries. The improvement starts automatically once the mower returns to the charging station.
Follow the instructions on the app. You can view the status from the status bar on the home page.
The result can be one of the following:
• Map accuracy improved: The boundaries, off-limit islands, and channels are all now updated with more accurate positioning.
• Map accuracy failed to be improved: The map has large areas with very poor GPS signal. The Camera-assisted Positioning failed because
the antenna is not at a proper location. To install the antenna somewhere else, you can try using the Satellite Signal Analyzer to find a better
location. You can check the app for other reasons of failure.
EFLS 2.0
Map accuracy improving
Camera-Assisted Positioning
Satellite Signal Ananlyzer