Publicité
Les langues disponibles
Les langues disponibles
3 Sensor with display/programming unit PP2000
If the sensor is connected to a display / programming unit
• it is supplied with operating voltage by this unit,
• it continuously transfers its data to this unit (measured values, signals
transferred to the evaluation electronics and parameter settings).
It provides the following options:
• Remote display
Indication of the current system pressure (in bar, PSI, MPa or kPa)
by an LED display.
• Remote evaluation
2 output signals are provided (or 1 signal in the Teach mode)
according to the set output configuration.
• Remote Teaching
setting to current system pressure by Teach function
• Programming / remote programming of the sensor
Parameters can be set before the sensor is mounted and set up or
during operation.
For programming: → operating instructions of the programming
unit.
For use of the sensor with PP2000 prior to installation of the sensor:
Use a suitable power supply (operating voltage 18 ... 30 V DC).
23
Publicité
