Kärcher 1.106-220.0 Manuel D'utilisation page 10

wand and hand tightening the thread-
ing of the gun onto the wand.
4. Pull the lever on the trigger gun to
make sure that water is flowing freely
and that all air has been purged from
the device.
NOTE: We recommend that you test
the GFCI as part of your startup
procedure each time you use the
device, see chapter GFCI
INSTRUCTIONS.
Do not use if GFCI fails test.
GFCI Instructions
1. Plug the Ground Fault Circuit Inter-
rupter (GFCI) into a working outlet.
2. Press "TEST", then press "RESET" to
assure proper connection.
10 English
1 2
NOTE: The actual appearance of the
GFCI may be different from this illustra-
tion.
Operation Instructions
ATTENTION
Pump running dry will cause
damage to the device.
If pressure does not build up in the
device after 2 minutes then switch the
device off and proceed according to
the instruction in chapter, Trouble-
shooting guide.
High Pressure Operation
NOTE: Maintain a spraying distance
of at least 12 inches (30 cm) when
cleaning painted surface. Do not get
closer than 24 inches (60 cm) (0r 2
feet) when washing a vehicle.
1. Install the nozzle with the quick con-
nect on the end of the wand by pull-
ing the collar back, inserting the soap
nozzle, then pushing the collar back.