Electrical Connections - S&P EMIDUAL-500P Manuel D'installation & D'utilisation

Placing metal wall brackets keep in mind that the right bracket must be
located in the lodging realised in the control box of the product. Warning: if you
do not respect this instruction the product may be instable!
- If installation becomes complicated due to the imperfect alignment of the holes,
adjust the position of the wall brackets by loosening the screw a little and moving
the connector vertically.
- Fixing the lower bracket(s) in a different position compared to above reported
distances is not recommended! Placing bracket(s) in a different position may
endanger product resistance to knocks. Always mind to insert the lower bracket(s)
between two following openings and newer totally inside only one to prevent side
movements (picture 6).

5. Electrical connections

The product must be powered at a voltage of 230V AC 50Hz.
The product must be supplied with a cable and plug or with a cable for installa-
tion. If a product with plug is installed in France, connect it to the mains power
supply by cutting off the plug and using a suitable connection box.
If the product is supplied with a cable for installation, connect it to the mains
power supply using a 3-wire cable (Brown=Live, Blue=Neutral, Black=Pilot wire)
and a connection box. If you do not wish to use the pilot wire functions, just
connect the phase and the neutral wires: the product will work correctly even
without the external programmer.
In bathrooms, kitchens or other humid areas, install the connection terminal at
least 25cm off the floor.
The electrical connection to the mains power supply must also include a 2-pole
switch with a minimum contact aperture of 3mm. As a priority, always abide you
national wiring rules.
It is forbidden to connect the appliance to the earth circuit. DO NOT CONNECT
THE PILOT WIRE (BLACK) TO THE EARTH CIRCUIT.
If the product is powered through a 30mA differential switch, make sure the pilot
wire is also controlled by the differential switch.
L
N
Phase (brown)
Pilot wire (black) – DO NOT CONNECT TO EARTH
Neutral (blue)
13