S&P EMIDUAL-500P Manuel D'installation & D'utilisation page 12

This product may not be used by people (children included) with reduced physi-
cal, sensorial or mental capacities, or with inadequate experience and knowled-
ge, unless they are under the supervision of a person responsible for their safety
or have been suitably instructed by the latter. Children must be supervised to
ensure they do not play with the product.
To prevent overheating, never cover the product inappropriately (pictures 9 and 10).
Do not use the product in rooms saturated with explosive gas, vapours generated
by solvents or paints or flammable vapours/gas.
If the cable and/or plug are damaged, do not repair them yourself but take the pro-
duct to the technical service or a qualified repair centre and have them repaired
by specialised personnel in order to avoid any risk of damage.
Always position the product so that the plug is immediately accessible.
Never position this appliance immediately underneath a power socket.
3. Safe positioning
Only use the product in its horizontal position;
This product is fitted with a double electrical insulation circuit (class II) and there-
fore does not require an earth connection;
Always make observe the minimum distances from walls, furniture and/or objects,
as indicated in picture 2.
Never install the product on a surface made from wood or synthetic material.
This product is water resistant to IP24. It may therefore be used in bathrooms or
other areas subject to humidity provided it is never installed within the perimeter
of bathtubs or showers (Volume 1 of figure 2).
It must never be possible for people in the bath tub or shower to reach the adjust-
ment knobs.
4. Installation
After carefully reading section 3, proceed with installation following the sequence
shown in figures 4 to 8.
Distances indicated in picture 4 are:
EMIDUAL-500P
EMIDUAL-800P
EMIDUAL-1300P
Model X (mm)
Min 270 - Max 340
Min 400 - Max 500
Min 600 - Max 800
Y (mm) Z (mm)
535
535
535
12
165
265
463