Publicité
Les langues disponibles
Les langues disponibles
4.
Turns the fan on and Increases fan speed.
5.
Switch the fan speed between nature mode and normal mode. Simulate a
natural breeze to make you comfortable when you sleep.
Note: Press/hold this button for 5 sec. to turn off the beep. Press/hold button
for 5 sec. again to turn it on.
6.
Turns the lights on or off and RF pairing.
Note: Press/hold button for 5 sec. within 10 min. of plugging fan to power
source to pair remote and fan.
7.
Switch between warm light and cool light. WIFI Trouble shootings.
Note: Press/hold button for 5 sec. till beep alert. The fan will switch to AP
Mode, then select AP Mode on APP, follow the APP control instructions will
enable fan Wi-Fi.
8.
Press/Hold button to decrease the desired light level.
9.
Press/Hold to button to increase the desired light level.
Warning: Do not expose the remote control to rain or water.
Install / Replace Batteries
Use two dry alkaline batteries (1.5V). Do not use rechargeable batteries.
1.
Remove the battery cover on the back of the Remote Control
2.
Insert new batteries making sure that the (+) and (-) of battery are installed
correctly.
3.
Reattach the cover by sliding it back into position.
NOTE!
•
When replacing batteries, do not use old batteries or a different type battery.
This may cause the remote controller to malfunction.
•
If you do not use the remote controller for several weeks remove the
batteries. Otherwise battery leakage may damage the remote controller.
•
The average battery life under normal use is about 6 months.
•
Replace the batteries when there is no answering from the unit
•
Never mix new and old batteries. Never use different battery types (e.g.
alkaline and manganese dioxide) simultaneously.
•
Non-rechargeable batteries are not to be recharged
•
Batteries are to be inserted with the correct polarity
•
Exhausted batteries are to be removed from the appliance and safely
disposed of
•
If the appliance is to be stored unused for a long period, the batteries should
be removed
•
The supply terminals are not to be short-circuited
4
55
Publicité
