Qlima FC 260 Manuel D'utilisation page 50

(Fig. 6)
2.2 Insert the 2P terminal and the 3P terminal into the corresponding terminal
2.3 Snap the small cover into the hole of the lampshade and tighten it in the
(Fig. 7)
Warning: Make sure you tighten the screw to secure the lampshade, otherwise
ATTACH DOWNROD
3.1 Assemble down rod as pictured in Fig.9. (Please select the suitable length of
(Fig. 9)
4
50
interfaces on the circuit board, and then install the M4x8 screw to secure the
lampshade in place. (See Fig 7)
direction indicated by the arrow. (See Fig 8)
the lampshade will loosen or drop down when the fan is running.
rod for your ceiling.)
NOTE: If you choose to install a safety Cable/chain onto your ceiling fan, you
will need to run it through the downrod prior to installation.
(Fig. 8)