Qlima FC 260 Manuel D'utilisation page 51

3.2 Remove the screw which already fixed in side of motor shaft, then connect
the safety cable with motor shaft firmly by this screw. (See Fig 10)
Connect the wiring harness from the down rod to the receptacle from the
motor wire as Fig.11. After finished, hide the wire into down rod.
NOTE: Take out the end of the safety cable from downrod before lowering
the downrod onto motor hub.(See Fig 12)
Install the screws and washers in opposite directions from each other (2 sets
on each side) and make sure the screws and washers are tightened firmly
with a screwdriver.(See Fig 13)
(Fig. 10)
ASSEMBLY
HANGING THE FAN
Install the mounting bracket to the ceiling box, as shown in Fig 14 below. Rotate
the mounting bracket in different directions so that the bracket mounting holes
match the screw holes of the ceiling box.
Note: This mounting bracket is a standard cable box.If the mounting bracket
is installed at the outlet box, it should be installed on the outlet box with two
screws matching the outlet box itself, as shown in Fig 14.
This bracket can also be mounted to the wooden ceiling beam, and then the four
STx24 screws can be used to lock the corresponding holes on the left and right
sides of the bracket.
Note: The wooden ceiling beam must meet the tensile test of 30KG for installation,
as shown in Fig 15. It is also possible to install the mounting bracket directly to the
concrete ceiling and install four screws to the left and right corresponding holes
of the bracket to lock the ceiling, as shown in Fig 16.
(Fig. 14)
(Fig. 11)
(Fig. 15)
(Fig. 12) (Fig. 13)
(Fig. 16)
4
51