Braun 390cc-4 Mode D'emploi page 11

C Clean&Renew
Braun Clean&Renew has been developed for cleaning, charging and storing
your shaver. Clean your shaver daily in the Clean&Renew.
During the automated cleaning process, the shaver is switched on and off
at intervals to obtain best cleaning results. Since the specially formulated
cleaning fluid contains a small amount of oil, the cleaning procedure also
fulfils the lubrication needs of the shaver.
Important
• Only use the power supply special electric cord set supplied with the shaver.
• In order to avoid any leakage of the cleaning fluid, place the appliance on a
flat, stable surface. Do not tip, move suddenly or transport in any way if a
cleaning cartridge is installed.
• Do not place the appliance in a mirror cabinet, nor store it over radiators,
nor place it on polished or lacquered surfaces. Do not expose to direct
sunlight.
• The appliance contains flammable liquid. Keep it away from
sources of ignition. No smoking.
• Keep out of reach of children. Do not refill cartridge. Use only
original Braun refill cartridge.
Description
1 Start/release button
2 Contact bow
3 Lift button for cartridge exchange
4 Level indicator
5 Cleaning cartridge
Before using Clean&Renew
Installing the cartridge
• Press the lift button (3) to open the housing.
• Hold the cartridge down on a flat, stable surface (e.g. table). Carefully
remove the lid from the cartridge. Slide the cartridge into the base as far as
it will go.
• Slowly close the housing by pushing it down until it locks.
Replacing the cartridge
After having pressed the lift button (3) to open the housing, wait for a few
seconds before removing the used cartridge.
11