Publicité
Photo 3
NOTICE DE MONTAGE
Couper le bandeau de mousse fourni en pièces de 10mm puis collez-les au bas du cadre de protection
radiateur, de façon à ce qu'elles se placent entre la protection radiateur et le radiateur.
En partant du côté droit (Lorsqu'on est assis sur la moto), enlever le boulon indiqué sur la Photo 1.
Du côté gauche, Enlever le boulon indiqué sur la Photo 2.
Monter la nouvelle grille de radiateur R&G en position en alignant les 2 points de fixation supérieurs sur le
radiateur comme à l'origine (voir Photo 3). Fixer la grille de protection radiateur en utilisant les boulons
d'origine enlevés plus tôt des 2 côtés puis serrer à maximum 15Nm.
Dans le kit, prendre les colliers de serrage fournis puis passer un collier de serrage dans chaque trou de coin
inférieur puis dans la matrice de radiateur, voir Photo 4. Bloquer les colliers de serrage en position.
Notice disponible au téléchargement sur
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do not diminish their
performance or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no representation or warranty (other than as to
title) has been given or will apply to the Products other than those in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of
merchantable quality and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care and
rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the motorcycle is not affected
by the fitting of the Products. On return of any defective Products R&G shall at its option either supply a replacement or refund the purchase money but shall not be
liable if the Products have been modified or used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good engineering
practice or if the defect arises from accident or neglect.
Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be liable for indirect or consequential loss
and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect the Buyer's
statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were purchased direct from us
(customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable condition, in the opinion of R&G All returns are subject
to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage
charges. No returns of discontinued products, unless within 14 days of purchase. This policy does not affect your statutory rights and does not refer to faulty goods.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
V
ALEURS DE SERRAGE RECOMMANDEES
M4 BOULON = 8Nm
M5 BOULON = 12N
M6 BOULON = 15N
ISSUE 1 01/11/2017 (HH)
CONSUMER NOTICE
R&G RETURNS POLICY (NON-FAULTY GOODS)
R&G
www.rg-racing.com
SRG0058
Photo 4
:
M
M
www.rg-racing.com
Email:
info@rg-racing.com
Publicité
