Publicité
•
La grille plastique peut maintenant être enlevée de la moto, en déclippant le bord externe, puis
en enroulant le support supérieur sous la grille plastique dont le rivet a été enlevé au dessus du
radiateur avant de tourner la grille vers l'extérieur du radiateur et en décrochant l'onglet du
bord interne de la grille, voir photos 5 & 6.
•
Avec la grille plastique, installez la protection radiateur R&G du coté gauche sur le radiateur puis
réinstallez les 2 supports de radiateur d'origine dans la protection radiateur et dans les supports
radiateur, voir photo 8.
•
Remonter le cache plastique en réalisant la procédure inverse de lorsqu'il a été enlevé.
•
Veiller à ce que la protection radiateur soit correctement montée et que tous les boulons et
rivets soient remontés.
•
Reconnecter le capot et vérifier que tous les feux fonctionnent.
•
Pour monter la protection radiateur du coté droit de la moto, répéter la procédure du coté droit
de la moto (En enlevant la partie sur le démontage du capot et sa réinstallation) en utilisant la
protection radiateur restante du coté droit.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do not
diminish their performance or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no representation or
warranty (other than as to title) has been given or will apply to the Products other than those in R&G's order or confirmation and the Buyer confirms it
has chosen the Products as being of merchantable quality and suitable for its particular purposes. Where R&G fits the Products or undertakes other
services it shall exercise reasonable skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is
responsible for ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall
at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have been modified or used or maintained
otherwise than in accordance with R&G's or manufacturer's instructions and good engineering practice or if the defect arises from accident or neglect.
Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be liable for indirect or
consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These
terms do not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were purchased direct
from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable condition, in the opinion of R&G
Racing. All returns are subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase). The
customer must pay any and all carriage charges. No returns of discontinued products, unless within 14 days of purchase. This policy does not affect your
statutory rights and does not refer to faulty goods.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1 24/02/2016 (AR)
Notice de montage sur
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
R&G Racing
www.rg-racing.com
www.rg-racing.com
Email:
info@rg-racing.com
Publicité
