Publicité
Les langues disponibles
Les langues disponibles
1. Part of Ground-link strap must be cut out and removed.
A.
Ground-link strap
B.
Ground-link screw
2. Use a Phillips screwdriver to remove the ground-link screw
from the back of the range. Save the ground-link screw and
the end of the ground link under the screw.
3. Pull the wires through the strain relief on bottom of range.
Allow enough slack to easily attach wiring to the terminal
block.
A
H
D
A.
Terminal block
B.
Ground-link
screw
C.
Cord/conduit
plate
D.
Bare (green)
ground wire
16
A
B
B
G
E
F
E. Line 2 (red) wire
F. Neutral (white) wire
G. Line 1 (black) wire
H. Ground-Link strap end piece
4. Attach terminal lugs to line 1 (black), neutral (white), and line 2
(red) wires. Loosen (do not remove) the setscrew on the front
of the terminal lug and insert exposed wire end through
bottom of terminal lugs. Securely tighten setscrew to torque as
shown in the following Bare Wire Torque Specifications chart.
C
A.
B.
C.
Bare Wire Torque Specifications
Wire Awg
8 gauge copper
6 gauge aluminum
5. Use a hex or Phillips screwdriver to connect the bare (green)
ground wire to the range with the ground-link screw and
ground-link section. Insert the ground-link screw through the
ground-link strap end piece and the green ground wire. The
ground wire must be attached first.
6. Use 3/8" (9.5 mm) nut driver to connect the neutral (white)
wire to the center terminal block post with one of the 10-32
hex nuts.
C
A
B
H
C
A.
B.
C.
D.
7. Connect line 2 (red) and line 1 (black) wires to the outer
terminal block posts with 10-32 hex nuts.
8. Using a torque wrench, tighten the hex nuts to a
recommended torque of 20 in-lbs (2.3 N-m).
9. Securely tighten hex nuts.
IMPORTANT: Verify the tightness of the hex nuts.
10. Replace terminal block access cover.
11. Reconnect power.
A
D
E
D. Neutral (white) wire
Terminal lug
E. Line 1 (black) wire
Setscrew
Line 2 (red) wire
Torque
25 lbs-in (2.8 N-m)
35 lbs-in (4.0 N-m)
E. Neutral (white) wire
10–32 hex nut
F. Line 1 (black)
Line 2 (red)
G. Terminal lug
Bare (green) ground
H. Ground-Link strap end
wire
piece
Ground-link screw
B
G
F
E
D
Publicité
