Resus Risycor CX Manuel page 40

■ 11 REPLACEMENT
The probe must be replaced if a fault occurs or when the probe tip has
been used up.
PRESSURELESS REMOVAL OF THE FAULTY PROBE
In the absence of pressure, the old probe can simply be unscrewed, i.e.
the reverse of screwing it in during the initial installation (see Chapter
6, Installation).
The removal of the probe must be carried out with the
necessary caution by a qualified person.
What should be done with the old probe? see Chapter 12,
Decommissioning.
PRESSURELESS INSTALLATION OF A NEW PROBE
If the system is not under pressure (or at least the part where the
probe is to be installed), the new probe can simply be screwed in,
as described earlier during the initial installation (see Chapter 6,
Installation).
REPLACEMENT UNDER PRESSURE
If the system cannot be made pressureless, it is possible to replace the
probe with the help of a Retractor (see Chapter 14, Accessories).
■ 12 DECOMMISSIONING
The logger and the probe can be decommissioned at the end of their
life cycle. See Chapter 11, Replacement for the dismantling instructions
of the probe.
What should be done with the old logger and probe?
Preferably return the logger and probe to Resus.
(See below for the address details) Do not throw it away.
The removal of the probe must be carried out with the
necessary caution by a qualified person.
40