Publicité
Les langues disponibles
Les langues disponibles
■ 6 INSTALLATION
See also the 'Application Guideline' document, where the philosophy of
the use of the Risycor is explained in detail (www.resus.eu).
PREPARATION
•
The corrosion monitor is best installed according to our Application
Guideline, in a place where there is sufficient flow (exception: the
pressurization/expansion line). The water must flow completely
around the tip of the probe. The installation location must be
pressureless at the fitting location during first installation.
•
Installation location:
a.
installed in the general return of the system.
b.
will contribute to a better system analysis. Install additional
Risycors in the return of risk circuits and/or risk components.
•
Select a location with space all round in order to be able to use the
Retractor for extension under pressure, where necessary.
20 cm
•
Avoid placing the Risycor in extreme sunlight and align the Risycor
in a position where the connectors will be protected against
splashing water.
30
When installing a single Risycor: this should preferably be
When installing multiple Risycors: additional Risycors
60 cm
OK
Publicité
