Resus Risycor CX Manuel page 39

■ 10 READ-OUT
The measurement data can be read out sporadically. Reliable values
are available a few days after the start (see Chapter 8, Data storage).
READ-OUT VIA USB
1. Download the free Resus PC Dashboard via www.resus.eu.
2. Install the Resus PC Dashboard.
3. Connect the logger to a PC. This can be done by using the USB
cable from the mains adaptor or via a separate (standard) USB
cable in the second USB-C connector.
CAUTION! The USB ports cannot be used to carry out 2 read-outs at
the same time.
4. The measurement data can now be read out. Follow the steps in
the Resus PC Dashboard.
5. If the USB cable from the mains adaptor was used, do not forget to
reconnect it correctly.
READ-OUT VIA INTERNET (CXI)
1. Open any web browser on a device that has access to the internet.
2. Surf to the website http://cloud.resus.eu/ to open the Resus
Cloud Dashboard, or go to the supplier-specific cloud application.
3. When using this for the first time, you must register as a user and
add the corrosion monitor(s) to the Resus Cloud Dashboard.
A corrosion monitor can be added in two ways:
a. Scan the QR code on the green logger with your smartphone
(which is connected to the internet). You can then log in (or
register if this has not already been done) on the website that
opens up;
b. Add the corrosion monitor manually by entering the serial
number and activation code into the website. These can be
found on the logger.
4. The measurement data can be read-out via the website, as well as
data for the further analysis of alarms.
EN
39