Publicité
Les langues disponibles
Les langues disponibles
10
PREPARE THE LOCATION
Style 2 - Cut Openings for 7" (17.8 cm) Round
Vent to Round Vent Transition
Roof Venting
To make a circular vent opening on the underside
of the cabinet top:
1. Mark a centerline on the underside of the top
of cabinet.
2. Mark a line 5" (12.7 cm) from the back wall on
the underside of the top of cabinet.
3. Use a compass or a circle template to draw
a circle with a diameter of 7½" (19 cm). Use
saber or keyhole saw to cut the circular vent
opening.
4. Repeat steps 1-3 for the underside of the top
of the cabinet.
(19 cm)
*5"
(12.7 cm)
Install Vent System
1. Install vent through the vent opening in upper
cabinet or wall. Complete venting system
according to the selected venting method. See
"Venting Requirements" section.
2. Use caulking to seal exterior wall or roof
opening around the cap.
NOTE
Your model includes a 7" (17.8 cm) round
vent mounting plate inside the package.
NOTE
Before beginning installation, remove the
transition installed in your hood.
Centerline
*
Cabinet
cutouts
*
*From wall , not
cabinet frame
1. Lift the range hood up under cabinet and
determine final location by centering beneath
cabinet. Mark on the underside of cabinet the
location of the 4 keyhole mounting slots on the
range hood (See slot dimensions on page 9).
Set range hood aside on a covered surface.
A
A. Keyhole slot
2. Use ¹⁄
" (3 mm) drill bit and drill 4 pilot holes as
8
shown.
NOTE: Make the drill holes on the thin area of
the slot.
3. Install the 4 - .45 cm x 1.3 cm mounting screws
in pilot holes. Leave about ¼" (6.4 mm) space
between screw heads and cabinet to slide
range hood into place.
4. Remove the top round vent knockout.
A. Top round knockout
NOTE
The knockout should be removed with a
screwdriver or leverage element, not a
hammer.
A
A. Drill pilot hole
A
(6.4 mm)
A
Publicité
