Candy Brava CDIN 4S532PS/E Mode D'emploi page 108

Parameter adjustment is performed by

pressing the "OPTIONS" and "TABS"
buttons to change the value from YES to
NO and vice versa.
Switch off the dishwasher by pressing the

"ON/OFF" button for 3 secs to confirm
the new setting.
To turn the alarm on again, follow the same
procedure.
MEMO FUNCTION (Memorising
the last programme used)
The dishwasher must ALWAYS be off
before you start this procedure.
Open the door.

Turn on the dishwasher by holding the

"ON/OFF" button down for about 3 secs.
Hold down the "PROGRAMME SELECTION"

and "ON/OFF" buttons for about 5 secs.
The message "SETTINGS" will appear

on the display and the indicator lights of
the "OPTIONS" and "TABS" buttons will
be on.
Pressing the "PROGRAMME SELECTION"

button until the "MEMO FUNCTION"
parameter is selected.
Parameter adjustment is performed by

pressing the "OPTIONS" and "TABS"
buttons to change the value from "MEMO
MODE ON" to "MEMO MODE OFF" and
vice versa.
Switch off the dishwasher by pressing the

"ON/OFF" button for 3 secs to confirm
the new setting.
To turn the alarm on again, follow the same
procedure.
Enabling or disabling DEMO MODE
(be used exclusively in stores)
Enabling
The dishwasher must ALWAYS be off
before you start this procedure.
1. Open the door.
2. Turn on the appliance using the
ON/OFF button.
3. Press the "PROGRAMME SELECTION"
and "DELAY START" buttons together
for 5 seconds.
4. "DEMO MODE ON" will appear on the
display.
5. If no button is pressed for 30 seconds,
the programme will start, simulating the
start of a wash programme.
The PROGRAMME
OPTIONS/ DELAY START options are
enabled, and
buttons you can simulate the product's
functioning without starting a wash.
Disabling "Demo mode"
WARNING
Once installed, if the appliance works
correctly but the wash cycle does not
start upon pressing the Start button,
"Demo mode" may not have been
disabled.
The dishwasher must ALWAYS be off
before you start this procedure.
1. Open the door.
2. Turn on the appliance using the
ON/OFF button.
3. Press the "PROGRAMME SELECTION"
and "DELAY START" buttons together
for 5 seconds.
4. "DEMO MODE OFF" will appear on the
display.
5. Switch off the appliance.
108
SELECTION/
by pressing these