Candy Brava CDIN 4S532PS/E Mode D'emploi page 105

Programme interruption
Opening the door when a programme is
running is not recommended especially
during the main wash and final hot rinse
phases. However, if the door is opened
while a programme is running (for example,
to add dishes)
automatically. Close the door, without
pressing any buttons. The cycle will start
from where it left off.
WARNING:
If you open the door during the drying
cycle, an intermittent audio signal
advises you that the drying cycle has
not yet finished.
Changing a running programme.
Proceed as follows to change or cancel a
running program:
Open the door.

Keep the START/RESET button pressed

for at least 3 seconds. "RESET" will
appear on the display and acoustic
signals will be emitted.
Close the door of the appliance.

The running programme will be cancelled.

At this point a new programme can be set

using the "PROGRAMME SELECTION"
button.
WARNING:
Before starting a new programme, you
should check that there is still detergent
in the dispenser. If necessary, top up the
detergent.
Programme end
A 5 second buzzer will sound (if not muted)
3 times at 30 second intervals to signal that
the programme has ended.
the machine stops
Only for models with the "SMART DOOR"
option, during the drying phase the
door will open automatically and you
will have to wait until for the end-of-
cycle signal before removing the dishes.
"PERFECT RAPID ZONE"
(only on some models)
The "PERFECT RAPID ZONE" is identified
by the left side of the tub, in which two extra
washing arms will be activated during Rapid
programs (ZOOM 39' and Rapid 24') and
programs (UNIVERSAL,
UNIVERSAL PLUS and ECO PLUS) to
provide an extra washing force, more water,
in that zone.
Option buttons
The option buttons provide you with further
wash options, allowing you to customise the
wash programmes (see the table in chapter
17 for a list of programmes on which each
option can be enabled). Options are enabled (or
disabled) before starting the programme, using
the appropriate buttons. The relevant indicator
lights will appear (or disappear) on the display.
The option button should be enabled after
you have chosen the wash programme.
Press the button once to enable option
"HALF LOAD", or press twice to enable
option "SMART DOOR". The two functions
cannot be run simultaneously.
105
SANITISING,