Candy Brava CDIN 4S532PS/E Mode D'emploi page 107

"DELAY START" button
Dishwasher start time can be set with this
button, delaying start from 1 to 23 hours.
Proceed as follows to set a delayed start:
Open the door.

Turn on the dishwasher by pressing the

"ON/OFF" button for about 3 sec.
Select the washing programme.

Press the "DELAY START"

("0:30" will appear on the display).
Press the button again to increase the

delay (on each press the delay is
increased by 30 mins., up to a maximum
of 23:30.
When the delay is set on a programme:

- after pressing "START/RESET", the
countdown time "00:00" appears on the
display with flashing " : "
- if you press any button (except for the
"ON/OFF", "PROGRAMME SELECTION"
buttons), the programme name is displayed
for a single scroll on the display and
then the delay time is displayed again.
- When the time has elapsed, the programme
name is displayed for a single scroll on
the display and the remaining time will
be displayed as "0:00h".
To start the countdown, press the

"START/RESET" button. The display will
show the time remaining to the end of the
programme. At the end of the countdown,
the programme will start automatically.
If the delayed start is not confirmed by
pressing the "START/RESET" button,
after approx. 10 sec. the delayed start
will be cancelled.
(Only for free-standing models)
The length of the selected cycle will
be shown on the display. At the end of
the countdown, the programme will
automatically start and the length of
the selected cycle will be shown on
the display.
Proceed as follows to cancel a delayed
start:
Hold the "START/RESET" button down

for at least 3 seconds. "00" will appear on
button the display "RESET" and audible signals
will sound.
The delayed start and the selected

programme
dashes will appear on the display.
 At this point, to set off the dishwasher, a
new programme and any option buttons
must be selected, as indicated in the
"PROGRAMME SETTINGS" paragraph.
Activation/Muted END-OF-
PROGRAMME signal.
You can deactivate turning on and off of the
audio signal as follows (the default setting is
active):
The dishwasher must ALWAYS be off
before you start this procedure.
Open the door.

Turn on the dishwasher by holding the

"ON/OFF" button down for about 3 secs.
Hold down the "PROGRAMME SELECTION"

and "ON/OFF" buttons for about 5 secs.
The message "SETTINGS" will appear

on the display and the indicator lights of
the "OPTIONS" and "TABS" buttons will
be on.
Pressing the "PROGRAMME SELECTION"

button until the "BUZZER" parameter is
selected.
107
will be cancelled. Two