Candy Brava CDIN 4S532PS/E Mode D'emploi page 103

15. PROGRAMME SELECTION
AND SPECIAL FEATURES
ON/OFF button
To turn the appliance on and off, press

the ON/OFF button (for at least 3
seconds).
At the end of the cycle, remember to
switch off the appliance using the
ON/OFF button, then remove the plug
and close the water supply.
First time you switch on the
appliance
Connect the machine to the power

supply.
 Open the door, put the dishes to be
washed inside, and close the door again.
Press the "ON/OFF" button and hold for

about 3 seconds.
In this phase only the "OPTIONS"

"TABS" and "START/RESET" buttons will
remain active. The message "BRAVA"
will appear on the display and all the
indicator lights will turn on for 3 secs.
The message "ENGLISH" will appear on

the display.
Pressing the "OPTIONS" and "TABS"

buttons you can select the preferred
language.
To accept the language selection press

the "START/RESET" button Immediately
afterwards the "WELCOME" message
will scroll on the display once and the
indicator lights will all be off.
"ECO" will appear on the display.

Press "START/RESET" and a signal will

sound, the indicator light corresponding to
the selected programme will stay on and
the wash indicator light will come on.
Close the door (after an audible signal

has sounded, the programme will start
automatically).
WARNING
In the event that the machine remains
switched on without selecting or
starting any program, after 5 mins. the
dishwasher will switch off automatically.
Next time you switch on the
appliance
Open the door.

Hold down the ON/OFF button for about 3

secs to turn the machine on and the
"ECO" programme or the programme you
have decided to use will appear on the
display, saving it when the dishwasher is
switched on. (To save the programme,
see the specific paragraph "Memorising
the last programme used").
Settings Menu
The dishwasher is regulated with certain
factory settings. Nevertheless, from the
Settings menu, you can adjust various
parameters to suit your washing requirements.
Entering the Settings menu
The dishwasher must ALWAYS be off
before you start this procedure.
Open the door.

Turn on the dishwasher by holding the

"ON/OFF" button down for about 3 secs.
Hold down the "PROGRAMME SELECTION"

and "ON/OFF" buttons for about 5 secs.
The message "SETTINGS" will appear

on the display and the indicator lights of
the "OPTIONS" and "TABS" buttons will
be on.
Pressing the "PROGRAMME SELECTION"

button you can select the parameters to
be adjusted in succession (SOFTENER
→ BUZZER → MEMO FUNCTION).
103