Candy Brava CDIN 4S532PS/E Mode D'emploi page 87

2. WATER CONNECTION
The appliance must be connected to
the water mains using new hose-sets.
The old hose-sets should not be
reused.
The inlet and drain hoses can be directed

to left or right.
The dishwasher can be connected to
either cold or hot water, as long as it
is no hotter than 60°C.
Water pressure must be between 0,08

MPa and 0,8 MPa.
The inlet hose must be connected to a tap

so that the water supply can be cut off
when the machine is not in use (fig. 1 B).
The dishwasher is fitted with 3/4" threaded

connector (fig. 2).
Connect inlet hose "A" to water tap "B"

with a 3/4" attachment making sure that it
has been properly tightened.
If it is necessary, the inlet pipe can be

lengthened up to 2,5 m. The extension
pipe is available from the After Sales
Service Centre.
If the dishwasher is connected to new

pipes or to pipes which have not been
inuse for a long time run water through for
a few minutes before connecting the inlet
hose. In this way no deposits of sand or
rust will clog up the water inflow filter.
87