Migatronic MWF 5-MIG Manuel D'instructions page 8

Connection to power source
The wire feed unit MWF 5 is designed for connection
to the MIGATRONIC
335/445/545.
Configuration
MIGATRONIC disclaims
damaged cables and other damages related to
welding with under sized welding torch and welding
cables measured by welding specifications e.g. in
relation to permissible load.
Dispose of the product according to local
standards and regulations.
www.migatronic.com/goto/weee
Important!
In order to avoid destruction of plugs
and cables, good electric contact is
required when connecting earth
cables and intermediary cables to
the machine.
Technical data
100% duty cycle
60% duty cycle
Wire speed
Mains voltage
Efficiency
Torch connection
Dimension wire reel
Separate wire reel
Separate intermediary cable
1
Protection class
1
Equipment marked IP23 is designed for indoor and outdoor
applications
power source MIG
all responsibility for
MWF 5
425 A
550 A
1 - 24 m/min
40 V AC
250 VA
EURO
200 mm
no
yes
IP23
Technical description
1. Wire feed speed control
2. Switch for 2/4-times, spot welding and MMA-
welding
3. Volt/Ammeter
4 Torch watercooling connection
5. Soft start ON/OFF and soft start function
control. By adjustment to max. value the soft
start is automatically disconnected. The MWF
returns to set value.
6. Spot welding timer (the spot welding time is
measured from the time when the arc is
started).
7. Burn-back control
8. Gas post-flow timer
9. Wire-inching control
10. Connection of torch
11. Control cable connection
12. Welding cable connection
13. Shielding gas connection
14. Fuse 5A
8