Bosch FPP 5000 Manuel D'installation page 18

18 en | Technical data
Notice!
i
Make sure that the temperature sensor of the power supply bracket is connected.
Notice!
i
Only use one battery pair which can be connected either to terminal BAT1 or terminal BAT2
of the battery controller module.
See first graphics page for illustration of components.
Position
1
2
3
4
5
6
7
*only used in FPP 5000 kit
The panel rail PRS 0002 C is fitted with a BCM‑0000‑B battery controller module. The
battery controller module monitors the power supply and controls the charging of the
batteries (e.g. 2 x 12 V / 45 Ah), subject to temperature parameters and set times. The
green LED shows that the unit is operational.
The universal power supply UPS 2416 A is inserted into the power supply bracket, and is
immediately operational via the pre-wired plug-and-socket connections. It is protected
against excess voltage and reversed polarity. The output voltage is monitored and controlled
externally. The output FAULT signals that a malfunction has occurred.
The power supply bracket has a temperature sensor.
4 Technical data
FPP-5000 Electrical
AC mains:
Input voltage range (nominal)
Input voltage
(VdS-approved according to EN54)
Input frequency range
Power source (EN 62368-1)
Electrical source (EN 62368-1)
Terminals 24 V+/- ①, 24 V+/- ②:
Output voltage (min-max)
2024-05 | 09 | F.01U.005.065
Description
PMF 0002 A Power supply housing medium for frame mounting*
BCM-0000-B Battery controller module
FMH 0000 A Mounting frame medium
PRS-0000-C Panel rail short, can hold 2 modules
USP 2416 A Universal power supply
FPO-5000-PSB2 Power supply bracket*
2 battery slots (batteries have to be ordered separately)
Installation manual
110 - 240 V AC
230 V AC + 10% / -15%
50 Hz to 60 Hz
PS 3
ES 3
20.4 - 30 V battery-buffered
Bosch Sicherheitssysteme GmbH
External power supply kit