Beurer MP 62 Mode D'emploi page 26

- Turn the control ring to the left (anti-clockwise rotation) or to the right
(clockwise rotation) to switch the device on. The LED lights up blue.
The two buttons marked with plus (+) and minus (-) allow you to se-
lect the speed of rotation. Start every application at low speed and
increase it only as required.
- All file and cutting attachments are coated with a sapphire grain.
This guarantees extremely long life and almost guarantees freedom
from wear.
- Do not exert heavy pressure and always guide the attachments ca-
refully over the surface to be treated.
- Move the instrument under light pressure in circular movements
slowly over the parts to be treated.
- Note that the cutting attachments will have a reduced e ect if the
skin is softened or moist. For this reason, do not carry out any pret-
reatment in a bath.
- Do not remove all the callus skin in order to retain the natural pro-
tection of the skin.
- Always ensure that the spindle can rotate freely. It must never be
permanently jammed, otherwise the instrument will become too hot
and su er damage.
- After every use, apply moisturizing cream to the parts treated.
Attachments
– Sapphire Cone
A
Suitable for removing dry skin and softening calluses on the sole and
heel. Take care not to remove hardened skin entirely to protect the
healthy skin beneath. File until a thin layer remains then moisturise to
soften.
– Coarse Sapphire Cone
B
Suitable for removing hard skin and large calluses from the sole and
heel. Take care not to remove hardened skin entirely to protect the
healthy skin beneath. File until a thin layer remains then moisturise to
soften.
26