Publicité
Les langues disponibles
Les langues disponibles
Preparing your harness
Installation of the reserve parachute
9 Position the handle so that the small label with the Velcro
attaches to the harness.
(Step 5)
10 Insert the tab of the rigid flap inside the handle so that it
slides into the opening provided for this purpose.
The tab will then be held in position using the internal magnet.
11 Raise the zip slider as far as possible towards the handle,
then lower it to correctly close the container.
At the end of assembly, it is imperative to check scrupulously that
At the end of assembly, it is imperative to check scrupulously that
no assembly tools are left in place (rod, hanger). This would
no assembly tools are left in place (rod, hanger). This would
make it impossible to extract the parachute if necessary.
make it impossible to extract the parachute if necessary.
More detailed information is available at www.korteldesign.com.
More detailed information is available at www.korteldesign.com.
2
(Step 6)
(Step 7 and 8)
50
1
Step 5
3
Step 7
KARMA III
Rescue handle
1
Velcro sticker
2
Rigid shutter
3
Closing zipper
4
3
Step 6
STEP 8
Publicité
