Kortel Design KARMA III Notice D'utilisation page 47

Preparing your harness
Installation of the reserve parachute
The harness is equipped with a special pod, directly connected
to the rescue handle.
S
Such a pod is included with your harness. It is imperative that
you repack your rescue parachute into the relevant pod:
- Rescue pod with a volume between 3,1L and 4.5L
S
- Rescue pod with a volume between 3.9L and 5.0L
M
- Rescue pod with a volume between 4.7L and 6.0L
L
If the pod you received does not match the size of your rescue
parachute, please contact KORTEL DESIGN.
The packing of the rescue parachute must be done in accordance
The packing of the rescue parachute must be done in accordance
with the rescue parachute manufacturer's instructions. with the rescue parachute manufacturer's instructions.
Refer to the manual of the relevant rescue parachute. Refer to the manual of the relevant rescue parachute.
M L
The rescue parachute should be installed in the pod as follows:
1 Position the folded rescue parachute with the lines
positioned on the side of the double flap.
2 Close the 4 triangular flaps
with the elastic band and
secure with a line loop. The
closed volume can
adjusted with the different
eyelets .
3 Lay the line bundle along the last flap, securing the loops
with the elastic bands provided.
4 Fold down the last flap,
and lock the closure with the
2 elastics bands. It is possible
to separate the left and right
sides in the case of swivelling
parachutes.
47
KARMA III
be