Kortel Design KARMA III Notice D'utilisation page 48

Preparing your harness
Installation of the reserve parachute
The rescue parachute should be installed in the container as
follows :
1 Prepare the pod with the handle as described above.
2 Connect the rescue risers to the parachute using a suitable
connection (see page 46).
3 Connect the rescue risers to the shoulders, using a suitable
connection (see page 46).
Pod - handle assembly
1
Shoulder connection points
2
Closing zip
3
Zipped guide sleeve
4
Emergency container
5
Rescue handle
6
1
3
2
4
6
4. Insert the rescue risers in the guide sheath and close it with
its zipper. (Figures A /B /C). BE CAREFUL to properly position
the cursor at the end of the sheath or the correct opening of
the sleeve cannot be ensured! (Figure D)
Step A
5
48 48
KARMA III
Step B
Step C
Step D