Bosch NET8666SUC Manuel D'utilisation Et D'entretien page 16

and numbers A fault in the electronic system has
Display
"
and numbers A fault has been detected.
Display "
Error messages
"ƒ
"...
"‰
Notes
The cooktop regulates the heating element
▯
temperature by turning the heat source on and off; this
means that the reddish glow of the heat source
beneath the heating element may not always be
visible. If you select a low heat setting, the heat source
is frequently off; at higher settings it is seldom off. The
source turns on and off even at the highest settings.
You may hear a quiet hum when the heating elements
▯
are in the heating phase. The heating elements may
glow with different levels of brightness. Depending on
the angle from which you are looking at the heating
element, this glow may be visible over the marked
edge of the heating element. These are technical
characteristics. They have no effect on quality and
function.
Glass ceramic may have uneven areas on the surface
▯
due to the nature of the material itself. Because of the
mirror-like finish on the cooking surface, even
extremely small bubbles less than 1 mm in diameter
may be visible. These bubbles will not have any
adverse effect on the operation of the cooktop nor on
the durability of the glass ceramic cooking surface.
Depending on the countertop that is present in the
▯
kitchen, an uneven gap between the cooktop unit and
the countertop can occur. For this reason, a flexible
seal is provided around the entire cooktop unit.
16
occurred.
The element is too hot and has
turned off.
The touch control zone is too hot.
The element was in continuous use
for too long.
Turn the appliance off and back on at the fuse or cir-
cuit breaker. If the same fault occurs again, disconnect
the appliance and call Technical Assistance Service.
The following table of error messages lists actions you
can take to correct the problem
Remove the pans from the elements.
when you press the display, if the element has
cooled down sufficiently. Wait a few minutes until the
element has cooled down a bit. If
after the element is turned back on, the cooktop is
still too hot. Turn off the elements and allow them to
cool further.
Make sure that cookware is properly positioned on
the element, and no hot objects are in contact with
the touch control zone. Wait a few minutes until the
touch control zone has cooled down. If
after you turn on the appliance, call Technical Assis-
tance Service.
The automatic time limitation has been activated.
Touch any key. You can now turn on the heating ele-
ment immediately.
How to Obtain Warranty Service
To obtain warranty service for your Product, you should
contact the nearest Bosch authorized servicer.
E number and FD number:
When you contact Service, please have the Model
(E) number and the FD number for your appliance
available. You can find the identification plate with these
numbers on the underside of the appliance and in the
appliance booklet. To avoid having to search for a long
time when you need it, you can enter your appliance data
and the customer support telephone number here.
E-Nr.
Customer Service O
Questions? Please contact us. We look forward to
hearing from you!
disappears
"ƒ
appears again
"ƒ
appears
"...
FD-Nr.