Beta 1467LF/2 Mode D'emploi page 8

INSTRUCTIONS FOR USE
• Before any work on the machine itself, pull the mains
plug.
Problem
- The pump does not draw or build
up pressure
- No power to the unit
- The pump does not relieve
tions give above. You will be helped quickly and reliably.
.......................................
8
Maintenance and Cleaning
What is to be done in case of a Problem?
- Pressure regulator completely
closed or completely open.
- Suction hose is kinked aspirazione
- Air in the hose
- The shut-off valve 2 is in the
- Fuse defective
- The pressure regulator was
regulated downward during
Data: Date:
• Always keep the machine clean.
• Never clean the unit with a steam spray.
Cause
Declaration of Conformity
-
We declare under our sole responsibility that this product
is in conformity with the following standards an standardi-
sation documents: EN ISO 12100:2010, EN 60204-1, EN
61000-6-2, EN 61000-6-4 according to the provisions of
05
Corrective Action
- Replace the container
- Set the proper working pressure
(approx. 2 bar
- Remove kinks from the hose or
replace, if defective
- Vent the unit as for initial operation
- Replace the fuse
- Turn the pressure regulator to
the right to the relief point.
EN