EINHELL TE-MB 18/127 Li Mode D'emploi page 12

Always dispose of your battery pack according
to federal, state, provincial and local regulations.
Contact a recycling agency in your area for recycling
locations.
CAUTION! Even discharged battery packs
contain some energy. Before disposing, use
electrical tape to cover the terminals to prevent
the battery pack from shorting, which could cause
a fi re or explosion.
WARNING! To reduce the risk of injury or
explosion, never burn or incinerate a battery
pack even if it is damaged, dead, or completely
discharged. When burned, toxic fumes and
materials are emitted into the surrounding
atmosphere.
1. Batteries vary according to device. Consult
your manual for specifi c information.
2. Install only new batteries of the same type in
your product (where applicable).
3. Failure to insert batteries in the correct
polarity, as indicated in the battery
compartment or manual, may shorten the life
of the batteries or cause batteries to leak.
4. Do not mix old and new batteries.
5. Do not mix Alkaline, Standard (Carbon-Zinc),
or Rechargeable (Nickel Cadmium, Nickel
Metal Hydride, or Lithium-Ion) batteries.
6. Do not dispose of batteries in fi re.
7. Batteries should be recycled or disposed of
as per state, provincial and local guidelines.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
General safety information – Stationary
bandsaws
WARNING! Read all the safety information
and instructions supplied with the machine
and make sure that the electric tool is
correctly assembled. Failure to observe the
warnings and instructions might result in an
electric shock, fi re and/or serious injuries.
•
Pull the plug out of the power socket and/
or remove the battery from the electric
tool before you make any adjustments or
replace any accessories. Many accidents are
caused by the machine being switched on
accidentally.
•
Before you use the machine, assemble it
as described in the instructions in order to
reduce the risk of an accident.
Anl_TE_MB_18_127_Li_SPK7_NA.indb 12 Anl_TE_MB_18_127_Li_SPK7_NA.indb 12
EN
•
Do not overload the electric tool and never
use it on ladders or scaffolds.
Additional safety information – Bandsaws
•
Hold power tool by insulated gripping
surfaces, when performing an operation
where the cutting accessory may
contact hidden wiring. Cutting accessories
contacting a "live" wire may make exposed
metal parts of the power tool "live" and could
give the operator an electric shock.
•
Keep your hands out of the sawing area and
away from the blade.
•
Before you use the portable bandsaw, make
sure that it is clean.
•
Stop working with the machine if you ever
notice anything unusual. Before you use the
tool, always make sure that each component
is fitted properly and securely.
•
Always take care when you fit or remove the
blade.
•
Always keep your hands away from the
blade's cutting path.
•
Always wait for the motor to reach full speed
before you start to saw.
•
Always keep the handles dry, clean and free
of oil and grease. Hold the tool securely while
you are working with it.
•
Stay alert at all times, particularly when you
are carrying out repetitive, monotonous
operations. Take care that your hands are
always in the correct position relative to the
blade.
•
Never remove the workpiece stop.
•
Stay clear of end pieces that drop after
sawing. They might be hot, sharp and/or
heavy. The results could be serious injuries.
•
Air vents often cover moving parts and should
be kept clear. Loose clothing, jewelry or long
hair might become caught in the moving
parts.
SAVE THESE INSTRUCTIONS
- 12 -
28.02.2024 10:43:51 28.02.2024 10:43:51