Publicité
Les langues disponibles
Les langues disponibles
To clean the control module and the valves
• Remove the control module from the lid and
remove the timer: see the "Control module"
heading.
• Remove the timer.
• Wash the module under a gentle flow of running
water.
• Visually check that the steam release outlet (A) is
not blocked by seeing light through it as shown in
Fig.16
. If it is blocked, clean it under running
water. Refit the control module.
• Check that the operating valve (L) located inside
the lid is mobile, by moving the program selector
to "prog 1" and pressing with a finger
can only do this when the module is fitted on the
lid!
• You can clean this valve under running tap water.
• Also check that the safety valve (M) works properly
by using a cotton bud (for example) to press down
hard on the centre of the pipe, a part that should
Fig. 18
move
. You can clean this valve under
running tap water.
• You can also wash the control module in the
dishwasher, after taking care to remove the timer.
• Check that the steam release outlet seal (K) is in
place. If this seal is missing or has been damaged,
leaks may appear under the module when your
NutriCook is in use. The shape of the seal lets you
easily remove and refit it. If necessary, you can get
replacement seals from a TEFAL Approved Service
Centre.
• Check that the pressure indicator (D) is clean. It
can be cleaned under running tap water.
Never place the
timer in the
dishwasher.
Fig. 17
• Use a clean dry cloth.
• Never use solvents.
• Never place the timer under water.
Never dismantle the
control module.
Don't forget to
remove the timer
before cleaning the
control module by
hand or in the
dishwasher.
. You
Never use a cutting
or pointed object to
clean the safetly
valve (M).
To clean the timer
EN
13
Publicité
