Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE SAFETY PRECAUTION
a Under no circumstances should you ever take apart the brush cutter or alter it in any way. Doing so mingt result in the
brush cutter becoming damaged during operation or the brush cutter becoming unable to operate properly.
b. . Always be sure to turn off the engine before performing any maintenance or checking procedures.
c When sharpening, removing, or reattaching the blade, be sure to wear thick, sturdy gloves and use only proper tools
and equipment to prevent injury.
5.SET UP
HANDLE
1.Loosen the 4 bolts on the handle bracket.
2.Insert the right handle(throttle lever is attached)and the left handle assembly into
the braket and retighten the bolts securely.
(1)Handle bracket
(2)Right handle
(3)Bolt
(4)Left
(5)Engine side
SAFETY GUARD
Attach the safety guard to the gear care and fix it with the clump and 2 bolts
(M5X25)securely
THROTTLE WIRE
WARNING
After fitting up the handle make sure that the throttle cable is put in the
throttle lever.if not,it is very dangerous because the engine rotate after
releasing the throttle lever.
ADJUSTING THE THROTTLE CABLE
2. If the play is short or long, take off the air cleaner cover, loosen the lock nut and adjust the play.
INSTALLING THE MYLON CUTTER
1.Set correctly the inner holder and the outer holder to the gear shaft.
2.Screw the attached bold(M8 Left) into the gear shaft and secure it with the spanner.
3.Screw the nylon cutter into the bolt by fixing the inner holder with the L-shaped bar and tighten it manually.
NOTE
Keep bolts and washers to install the blade carefully so as not to lose them.
INSTALLING THE METAL BLADE
1.Set the inner holder to the gear shaft, and turn to fix with the attached L-shaped bar.
2.Put the blade on the inner holder with the face with letters to the gear case, and match correctly the hole of the blade to
the projection of the inner holder.
3.Set the outer holder to the gear shaft with the hollowed face to the blade.
4.Put the attached bolt cover on the outer holder and secure it with the bolt (left screw) together with the spring washer
and the washer.
69
Publicité
