Mi-T-M Corporation MH-0080-CM11 Manuel De L'opérateur page 13

ASSEMBLING THE HEATER
1. Remove heater from packaging. To protect your hands, put on gloves before lifting the outer shell. Never
grasp bare metal without gloves. (See Figure 1)
2. Lift outer shell straight up. Care must be taken to protect hands during lift. (See Figure 2)
Figure 1
3. Lift outer shell until all three clips engage slots located in the lower shell. When this happens, the screw
holes will line up. (See Figure 3)
4. Lock the clip into place with 3 screws as shown. The heater must not be operated unless the outer shell is
properly extended and fully locked into place. (See Figure 4)
Make sure the clip
goes into the slots
in the lower shell
(3 places).
Figure 3
WARNING: NEVER ATTEMPT TO LIGHT A HEATER UNTIL IT IS FULLY ASSEMBLED.
CONNECTING TO GAS SUPPLY
IMPORTANT! Always use a propane cylinder that has a connection device that is compatible with the hose
and regulator assembly supplied.
1. To connect hose and regulator assembly, rotate fitting on hose/regulator COUNTERCLOCKWISE into
threads on tank valve (see Figure 5 and 6). Be sure to tighten firmly.
Supply Valve
Regulator
Hose
Propane Tank
Figure 5
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A FUEL
SOURCE.
Propane Convection Heater Manual
ASSEMBLY
Figure 2
Lock the shells together
with the clips in place
and with a screw in
each clip (3 screws
total).
Figure 4
Connector
Inlet
Figure 6
Hose
13