Abus IPCB64620 Manuel Utilisateur page 78

Type:
Serial No.:
Firmware version:
Coding version:
Web version:
Plugin version:
Number of Channels:
Number of HDDs:
Number of Alarm Input:
Number of alarm outputs: Number of switching outputs on the camera
Memory usage:
Data throughput:
CPU usage:
7.4 System
7.4.1 Date & time
Time zone:
NTP:
Server address:
NTP port:
Interval:
Manual:
Synchronise with PC time:
Camera item number
Camera serial number
Display of the firmware version currently installed
Version number of the video encoder
Version number of the website
Version of the video plugin on the camera
Typically, only 1 channel is shown for a camera. A number of camera
channels may be available for IP encoders.
Display of the number of installed storage media (e.g. microSD card)
Number of switching inputs on the camera
Internal memory status
Total video and audio bit rate over the network interface (outgoing)
Display of the processor usage of the camera.
here, select the time zone in which the camera is located.
tick the box to synchronise the date and time of the camera with an
NTP time server.
enter the server address or the IP address for the NTP server here.
A standard server is already set up and can be adjusted if required.
enter the NTP port here. The standard port for NTP is 123.
select an update interval.
manual setting of date and time. Click in the date/time field to open
a configuration menu.
use the current PC time currently being used for access (after
saving the settings).
78