Publicité
TO INSTALL AND REPLACE BATTERIES IN THE WEATHER
STATION
TO INSTALL AND REPLACE BATTERIES IN THE THERMO-
HYGRO TRANSMITTER
Note:
In the event of changing batteries in any of the units, all units need to be
reset by following the setting up procedures. This is due to a random
security code assigned by the transmitter at start-up. This code must be
received and stored by the Weather Station in the first 3 minutes of power
being supplied to the transmitter.
BATTERY CHANGE:
It is recommended to replace the batteries in all units regularly to ensure
optimum accuracy of these units (Battery life see Specifications below).
RESETTING
The Weather Station and the Thermo-hygro transmitter need to be reset
when one of the following conditions occur:
•
Unsuccessful 915MHz signal reception.
The Weather Station uses 3 x AA, IEC
LR6, 1.5V batteries. To install and replace
the batteries, please follow the steps
below:
1.
Insert finger or other solid object in
the space at the bottom center of the
battery compartment and lift up to
remove the cover.
2.
Insert batteries observing the correct
polarity (see marking).
3.
Replace compartment cover.
The Thermo-hygro transmitter uses 2 x AA, IEC, LR6,
1.5V batteries. To install and replace the batteries,
please follow the steps below:
1.
Remove the cover.
2.
Insert the batteries, observing the correct polarity
(see marking).
3.
Replace the battery cover.
Please participate in the preservation of the
environment. Return used batteries to an
authorized depot.
25
Publicité
