Husqvarna 236RS Manuel D'utilisation page 15

6. Fill the fuel tank.
To add fuel
WARNING:
objects near fuel. Before you add fuel, stop
the engine and let it cool for minutes.
WARNING:
the fuel tank cap slowly to release unwanted
pressure.
WARNING:
the fuel tank cap carefully. Move the
machine away from the refuelling area and
the power before you start the engine.
• Always use a fuel container with an anti-spill valve.
• Make sure that the area near the fuel tank cap
is clean. Contamination in the tank can cause
operating problems.
• Shake the fuel container before you add the fuel
mixture to the fuel tank.
To start and stop
To examine before start
1. Examine the product for missing, damaged, loose or
worn parts.
2. Examine the nuts, screws and bolts.
3. Examine the blades.
4. Examine the locknut. Make sure that the locknut has
a minimum locking force of 1.5 Nm (1,1 ft lb). Torque
the locknut to 35-50 Nm (26-36 ft lb).
5. Examine the air filter.
6. Examine the throttle trigger lockout and the throttle
control.
7. Examine the stop switch.
8. Examine the product for fuel leaks.
To start a cold engine
WARNING:
product, install the complete clutch cover
and shaft. A loose clutch can cause injury.
Use gloves.
WARNING:
from the refuelling area and the fuel source.
Put it on a flat surface. Make sure that no
objects touch the cutting attachment.
WARNING:
unauthorised persons are in the work area.
2255 - 001 - 31.08.2023
Do not smoke or put hot
When you add fuel, open
After you add fuel, tighten
Before you start the
Move the product away
Make sure that no
Or it can cause a risk of dangerous injury.
The safety distance is 15 m.
1. Put the stop switch to the start position.
2. Push the air purge bulb until fuel starts to fill the
bulb.
3. Move the choke control to the choke position.
4. Hold the product to the ground. Pull out the starter
rope slowly with your right hand until you feel some
resistance.
Note:
Do not twist the starter rope around your
hand.
CAUTION:
rope to full extension. Hold the starter
rope handle when it is fully extended.
Failure to obey these instructions can
cause damage to the engine.
5. Pull the starter rope quickly and with force until you
hear that the engine starts.
Do not pull the starter
15