Husqvarna 236RS Manuel D'utilisation page 11

5. Put the handlebar assembly and the square nut into
the bracket. Make sure that the handlebar is in the
correct position.
6. Install the handlebar clamp (A), cover (B) and knob
(C).
7. Align the holes for the knob screw.
8. Tighten the knob to lock the handlebar tightly.
To install the harness
1. Put on the harness and hang the product from the
suspension point.
2. Adjust the handle to put the product in a good work
position.
3. Tighten the screws fully.
To connect the throttle cable and stop
switch wires
1. Remove the air filter cover.
2255 - 001 - 31.08.2023
C
B
A
2. Install the throttle cable (A) through the carburetor
bracket (B).
A
C
3. Turn the cable adjuster sleeve (C) into the carburetor
bracket fully.
4. Put the slot fitting (D) on the carburetor. At this time,
the recessed hole (E) for the cable lug (F) is away
from the cable adjuster sleeve (C).
G
5. Rotate the carburetor throttle cam and move the
throttle cable (A) through the slot in the slot fitting.
6. Make sure the cable lug (F) drops into the recessed
hole.
7. Operate the throttle trigger some times to make sure
that it operates correctly.
8. Adjust the cable adjuster sleeve (C).
a) Make sure the stop on the carburetor throttle
cam touches the throttle stop correctly.
b) Make sure the cable position keeps 1-2 mm
between cable lug (F) and slot fitting when the
throttle trigger is fully released.
1-2mm
9. When the throttle cable (A) is adjusted correctly,
tighten the locknut (G).
B
D E
F
11