Husqvarna 236RS Manuel D'utilisation page 13

6. Install the nut (E). Hold the shaft of the wrench
near the blade guard. To tighten the nut, you must
turn the wrench in the opposite direction of rotation.
Tighten the nut to a torque of 35-50 Nm/3.5-5 kpm.
Note:
Left hand thread.
To attach the trimmer guard and the trimmer
head
WARNING:
guard for the correct trimmer head.
1. Attach the trimmer guard (A) to the shaft with the
bolts (L).
L
A
2. Attach the drive disc (B) and support flange (G) to
the output shaft.
C
A
3. Turn the output shaft until the hole in the drive disc
aligns with the hole in the gear housing.
4. Put the locking pin or the hex key (C) in the hole to
lock the shaft.
2255 - 001 - 31.08.2023
Use the correct trimmer
A
H
G
B
5. Turn the trimmer head (H) counterclockwise.
H
6. To disassemble, do the reverse procedure.
To install the transport guard
1. Install the blade in the transport guard (A).
2. Put the two fasteners (B) into the slots (C) to attach
the transport guard.
B
A
To install the 2-teeth blade in the guard
1. Install the blade in the transport guard.
To adjust the harness
WARNING:
be correctly attached to the harness. Do not
use a damaged harness.
1. Put on the harness.
2. Connect the product to the harness.
3. Adjust the harness for the best work position.
C
The product must always
13