Publicité
Bulb Socket Assembly
Assemblage de la lampe
Casquillo portalámparas
Lift Agitator Up
Soulever l'agitateur
Unidad del agitador
Motor Shaft
Arbre d'entraînement
du moteur
Eje del motor
Replacing Headlight Bulb
Replacing Belt
+
+
Install
New Belt
Poser la
nouvelle
courroie
Instalación
de la correa
➢ ➢ Remove lower plate.
➢ ➢ Grasp the bulb socket and pull
upward while moving it back and forth.
➢ ➢ Remove old bulb from the socket by
pushing in while turning counter-
clockwise.
➢ ➢ Replace bulb by pushing in while
turning clockwise.
➢ ➢ Only use a bulb rated 130 Volts AC-15
Watts or less.
➢ ➢ Reinstall bulb socket into nozzle
housing by pushing it back down into
slot.
➢ ➢ Reinstall lower plate.
➢ ➢ Remove lower plate.
➢ ➢ Remove agitator by carefully lifting
out.
➢ ➢ Remove worn or broken belt.
➢ ➢ If end caps fall off, do not lose the
two (2) washers.
➢ ➢ Clean agitator and replace the two (2)
washers and end caps.
➢ ➢ Loop new belt (Panasonic Type UB8
only) around motor shaft and brush
pulley; see illustration for correct belt
routing.
- 28 -
Publicité
