Kinderkraft APINO Guide D'utilisation page 21

• Always use the restraint system.
• Check that the pram body or seat unit or car seat
attachment devices are correctly engaged before
use.
• This product is not suitable for running or skating.
• Age and weight usage: from 0 months up to 22 kg or 4 years whichever come first.
• We recommend using lowest reclined position for newborn babies.
• This product may only be used by one child at the same time
• The parking device shall be engaged when placing and removing the children
• The maximum basket load is 2 kg.
• Do not hang any bags on the parent handle.
• Any additional load, hanging on the handles of the stroller and/or behind the backrest and/or on
the sides of the stroller, causes deterioration of its stability.
• Use only parts and accessories supplied or recommended by the manufacturer. Do not use other
parts or accessories.
• Lift the front suspension when going up a curb or step.
• Do not place the product near open flame or other heat sources.
• Do not use with an additional platform.
• Stop using the baby carriage if you have any doubts concerning its usage or suspect any danger.
I. PUSHCHAIR COMPONENTS (FIGURE 1)
1. Seat (2) with safety harness (3) and canopy
4. Bumper
5. Front wheels x2
6. Rear wheels x2
II. ASSEMBLY OF THE PUSHCHAIR FRAME
The frame should be positioned on a flat surface with the guard rail facing up (FIGURE A). To unfold
the pushchair, start by pressing the parent handle to the pushchair frame in such a way that all the
components fit tightly together, and then lift the frame up in the direction of the arrows as shown
on the drawing (FIGURE B) until you hear the sound of the lock (FIGURE C). Slide the rear wheels (10)
into the designated openings until you hear the sound of the lock (FIGURE D). Slide the front wheels
(7) into the designated openings until you hear the sound of the lock (FIGURE E).
III. ASSEMBLY/DISASSEMBLY OF THE GUARD RAIL
Place the guard rail into the appropriate opening in the frame (FIGURE F). To disassemble, press the
buttons and remove the guard rail (FIGURE G).
IV. USING THE BRAKE
The pushchair is equipped with a foot-operated parking brake on the rear axle. Press the bottom
part of the brake down – once you hear the sound of the lock, the brake has been activated (FIGURE
H). To release the brake, lift the bottom part of the brake (FIGURE I).
V. ADJUSTMENT OF THE BACKREST AND FOOTREST
The seat features four-step backrest adjustment from the lie-flat position to the sitting position
(FIGURE J) using the backrest adjustment level (FIGURE K). The footrest can be adjusted to two
21