Publicité
Les langues disponibles
Les langues disponibles
Regularly clean the refrigerator to ensure proper operation. Before cleaning, switch off the appliance by setting the thermostat
to position OFF and unplugging the appliance.
Remove the food. Clean the interior of the appliance. Simply remove the shelf to clean them by hand. Use warm water and a
neutral detergent, such as baking soda, to prevent any bad smells occurring. Use two tablespoons and a quart liter of warm
water. After cleaning, rinse the interior with clean water and leave the door open to let it air dry for 1 to 2 hours before the
power is turned on. Be careful not to affect the electrical insulation properties when rinsing with water.
For areas that are difficult to clean in the refrigerator, such as narrow gaps or corners, it is recommended to wipe them
regularly with a soft rag, soft brush, etc. When necessary use some auxiliary tools, such as thin sticks (tooth picks), to ensure no
contamination can accumulate in these areas.
Clean the outside of the refrigerator and the door gasket with mild soap and water. Use a soft moist cloth.
We recommend that you dust the back of the appliance and on the floor with a cloth or vacuum cleaner once a year in order to
maintain a good output and low energy consumption.
Do not use hard brushes, cleaning steel wire balls, wire brushes, abrasives, such as toothpastes, organic solvents (such as
alcohol, acetone, oils, etc.), boiling water, acid or alkaline items to clean the refrigerator considering that this may damage the
fridge surface and interior. Boiling water and benzene may deform or damage plastic parts.
Breakdown
The appliance
no longer works
Temperature in the
refrigerator is too high or
too low
The appliance is working
continuously.
There is water
in the lower section of the
refrigerator.
CLEANING AND MAINTENANCE
RESOLVING FAILURES YOURSELF
Cause
There is an interruption
in the power supply.
Wrong setting of the thermostat.
The ambient temperature is higher
or lower than the
temperature indicated in the table
with technical data.
The appliance is located in direct
sunlight or near a heat source.
The ventilation at the rear of the
appliance is hindered.
The door of the refrigerator is
opened too frequently or remains
open for too long.
The door is not closed properly.
The compressor does not work
often enough.
The door rubber is loose.
Wrong setting of the thermostat.
The opening of the defrost water
drain is clogged.
The ventilation within the
refrigerator section is hindered.
Solution
- check that the plug is properly inserted in the socket
- check that the power cable is not damaged
- check that there is voltage on the socket by connecting
a different appliance, such as a night lamp
- ensure that the appliance is on by not setting the
thermostat to the OFF position
- turn the thermostat to a different position
The appliance is intended for operation in an
ambient temperature indicated in the table with technical
data supplied with the appliance.
Change the location of the appliance according
to the information in the instruction manual.
Keep the appliance 10 cm away from the walls,
for sufficient ventilation.
Open the door less often and/or reduce the time that
the door remains open.
Make sure the foods are placed in such a way that they
do not hinder the door when it is being closed.
Check that the ambient temperature is not lower than
the range of the climate class.
Fasten the door rubber or have it replaced.
- turn the thermostat to a higher position
Clean the opening of the defrost water drain by means
of the skewer.
Check that the food does not make contact with the rear
wall of the refrigerator.
EN - 22
Publicité
