Publicité
Les langues disponibles
Les langues disponibles
Set up the cable links in a sequence as follows. Connect the power cable between device
and power supply only after all other connections have been made.
Protective caps
Prior to the first installation the pro-
tective plastic caps must be removed
from all the connections used at the
rear of the unit.
RCA connections
Mechanically identical RCA
plugs are available for analogue and digital out-
puts. Make sure that you do not get these connec-
tions confused during installation!
Make sure that you do not mix up the analogue con-
nectors for right and left. The RCA plugs for these are
mostly colour coded as follows: red for the right chan-
nel, black or white for the left channel.
CONNECTION OF THE POWER CABLE
Make sure that the electricity supply to your home is appropriate to the device. The required voltage and fre-
quency can be read on the back of the device beside the socket for the mains. If the electricity supply is appro-
priate, push the inlet connector of the supplied mains cable firmly into socket for the mains on the back of the
device (15). Connect the other end of the mains cable to a mains socket.
A set of headphones equipped with a 6.3 mm jack can be plugged into the "PHONES" socket (4) on the front
of the appliance. All headphones with an impedance of between 32 Ohm and 600 Ohm may be used. Before
plugging-in the volume "LEVEL" should be reduced (5) for safety reasons.
Vincent
32
INSTALLATION
DURING INSTALLATION PLEASE OBSERVE
THE FOLLOWING ADVICE:
1
2
O UT PUT
O U
CONNECTING HEADPHONES
Cable connections
Make sure that all plugs fit tightly. Inadequate con-
nections can cause noise interference, failures and
malfunctions.
- wrong -
Cables
To make the most of the components' sound
potential, only high quality loudspeakers and
connecting cab les, for example Vincent cables,
should be used. Your local stockist will be glad to
advise you about this.
- correct -
Publicité
