VINCENT CD-400 Manuel D'utilisation page 28

11
10. ANALOG OUTPUT:
analogue audio signal output
This pair of RCA connectors is to be connected to
the relevant input of the amplifier, preamplifier
etc. It is not necessary to also connect the digital
signal output (12).
11. DIGITAL OUTPUT: coaxial signal output
If the amplifier, receiver or preamplifier is equip-
ped with a digital coaxial connector, this CD play-
er signal output may be connected to it. It is not
necessary to connect an analogue (11) and a
digital signal output (12) at the same time.
Vincent
28
REAR VIEW
12
12. POWER CONTROL (12V): ON/OFF control
13. FUSE: Fuse holder
14. AC: Power Connector
13 14
These jack connectors (3.5 mm) receive and for-
ward the signal for the standby control (12V
Trigger).
This small plastic housing holds the fuse. Refer to
the security precautions.
To establish the power supply, connect the plugs
of the power cable to the device and to a suitab-
le wall outlet.
15