Publicité
Les langues disponibles
Les langues disponibles
ELECTRODE SHARPENING
For optimal operation, it is recommended to use a sharpened electrode as follows:
CHOICE OF ELECTRODE DIAMETER
Ø Electrode
(mm)
Pure tungsten
1
1.6
2
2.5
3.2
4
TIG/GTAW LIFT PRIMING
1
2
The arc priming and stabilisation feature is designed for manual and mechanically guided operation.
Warning: Increasing the length of the torch or return cables beyond the maximum length specified by the manufacturer will increase the risk of
electric shock.
TIG/GTAW PROCESS SETTINGS
• The TIG DC is dedicated to the flow of ferrous metals such as steel, stainless steel, but also copper and its alloys and titanium.
• The Synergic TIG no longer works on the choice of a DC current type and the settings of welding cycle parameters, but integrates experience-based
welding rules/synergies. This mode therefore restricts the number of settings to three basic settings:
- The type of material.
- The thickness to be welded.
- The welding position.
Settings
Standard
Pulsed
Spot
Tack
Type of materials
Diameter of the Tungsten
electrode
Trigger mode
38
Constant energy welding
d
TIG/GTAW DC
Tungsten with oxides
10 > 75 A
60 > 150 A
75 > 180 A
130 > 230 A
160 > 310 A
275 > 450 A
~ 80 A per mm de Ø
3
1- Position the torch nozzle and the tip of the electrode on the metal piece and press the
trigger.
2- Position the torch to create a gap of roughly 2-3 mm between the tip of the electrode
and the metal. The arc starts.
3- Put the position back into position to start the welding cycle.
Adjustable
Designation
settings
Smooth current
-
Pulse current
-
Smooth poin-
-
ting
Pulse pointing
-
Fe, Al, etc.
1 - 4 mm
2T - 4T -
4TLOG
NEOFEED 4W
a
a = Ø 0.5 mm
L = 3 x d for a low current.
L = d for a high current
L
10 > 75 A
60 > 150 A
100 > 200 A
170 > 250 A
225 > 330 A
350 > 480 A
TIG
TIG DC
Synergic
-
-
-
-
-
Choice of the material to be welded
Choice of electrode diameter. Allows to refine HF priming
currents and synergies.
Choice of trigger welding management mode.
Constant energy welding mode with correction of arc length
-
variations
EN
Recommendations
Publicité
