Publicité
Les langues disponibles
Les langues disponibles
9
Reversing the door
The side at which the door opens can be
changed, from the right side (as supplied)
to the left side, if the installation site
requires.
Warning!
When reversing the door, the
appliance must not be connected to the
mains. Ensure that the plug is removed
from the mains socket.
Tools you will need
Not provided
8mm socket wrench
Cross-shaped
Monkey wrench
screwdriver
Additional parts(in the plastic bag)
Left Hinge Cover
Note: If required you may lay the
refrigerator on its back in order to gain
access to the base, you should rest it
on soft foam packaging or similar
material to avoid damaging the
backboard of the refrigerator. To
reverse the door, the following steps
are generally recommended.
1 . Use a putty knife or thin-blade
screwdriver to prize the screw hole
cover which is at the top left corner of the
refrigerator, and the upper hinge cover
which is at the top right corner of the
refrigerator.
2. Unscrew the special flange self-
Thin-blade
Putty knife
screwdriver
8mm wrench
tapping screws which are used for
fixing the right upper hinge part by a
8mm socket driver or a spanner
(please support the upper door with
your hand when doing it) .
3. Remove the upper hinge axis,
transfer it to reversed side and
tighten securely, then put it in a safe
place.
4. Remove the door from the lower
hinge.
NOTE :
When removing the
door,watch for washer(s) between
the lower hinge and the bottom of the
lower door that may stick to the door.
Do not lose.
Publicité
