AL-KO 3.82 SE Mode D'emploi page 20

Troubleshooting
Fault
Motor does not start
Loss of motor perform-
ance
Grass collection box
does not fill up suf-
ficiently
□ For faults not listed in this table, or which you cannot resolve by yourself, please contact our customer service.
474269_c
P ossible cause
No power supply
Machine cable defective
Blade jamm ed
Too much grass in the
ejection channel or
housing
Blade blunt
Lawn wet
Grass collection box
clogged
Too much grass inejec-
tion channel or housing
Blade blunt
Solution
Check fuse / extension lead.
Contact AL-KO Service Centre / authorized specialist work-
shop.
Clean ejection channel / housing; the blade must rotate
freely. Start on low grass or on the section of lawn that has
already been mown; correct the cutting height.
Clean ejection channel / housing.
Correct the cutting height
Contact AL-KO Service Centre or authorized specialist
workshop and have the blade sharpened/replaced.
Allow the lawn to dry.
Clean the grid of the grass collection box.
Clean ejection channel / housing. Correct the cutting height
Contact AL-KO Service Centre or authorized specialist
workshop and have the blade sharpened/replaced.
GB
20