HSM SECURIO B 32c Notice D'utilisation page 16

Other function modes
• Permanent mode
Application: Destroying large quantities of
paper
Function: Cutting unit runs continuously.
If no material is fed in within a period of
2 minutes, the cutting unit shuts down
and the shredder switches to standby.
Start: Press the on/off button for at least
4 seconds.
To cancel: Press the on/off button.
• Standby mode
Function: Two minutes after the last
paper feed operation, all consumers
that are not required are switched off
automatically.
The "Ready for operation" indicator goes
out briefl y at regular intervals.
The shredder starts automatically when
paper is fed in.
6 Troubleshooting
Display Problem
Paper
jam
Shredded
material
container
full
Door
open
06/2013
Measure
You have fed in too much paper.
 The cutting unit runs in reverse for a few seconds and pushes the pa-
per back out again.
• If necessary, press the reverse button "R" to remove the stack of paper.
• Take half the stack of paper.
• Feed the paper in portions.
Note:
This indicator lamp also lights up when the motor is overloaded. In this
case, let the shredder cool down for 20 minutes before using it again.
• Empty the shredded material container.
Note:
If you press the reverse button briefl y before removing the container,
part of the material is pulled back into the cutting apparatus.
• Close the front door.
SECURIO B 32
english
• Automatic shutdown
Function: If the shredder is not used for
one hour, it shuts down completely and
therefore does not consume any more
electricity (at night, at the weekend).
Restart: Press the operation button.
15