BorMann PRO BSS5300 Mode D'emploi page 4

EN
Warning symbols
WARNING - To reduce the risk of injury, user must read the
instruction manual
Always wear hearing protection
Always wear goggles
Always wear a breathing mask
In accordance with essential applicable safety standards of
European directives
Machine-related safety instructions
– Harmful/toxic dust can be produced during your work (e.g. lead-containing paint, some types of wood and metal). Contact with this dust, especially inhaling
it, can represent a hazard for operating personnel or persons in the vicinity. Comply with the safety regulations that apply in your country. Connect the electric
power tool to a suitable extraction system.
To protect your health, wear a P2 protective mask.
Always wear protective goggles to protect against sanding hazards.
– Use a residual current protective device when metal grinding, as well as when the operation of the power tool in a wet environment cannot be
avoided. In the event of an electric shock, the protective switch protects you against life-threatening current through the body.
– Clean work equipment soaked in oils, for example sanding pad or polishing felt, with water and allow to dry. Work equipment soaked in oil may
combust spontaneously.
– Attention: Risk of fire! Avoid overheating the grinding material and the sander. Always empty the dust container before taking a break. Swarf in
the filter bag or filter of the mobile dust extractor may self-ignite in unfavourable conditions such as flying sparks when grinding metals.
Particular danger exists if the swarf is mixed with paint, polyurethane residue or other chemical materials and the grinding material is hot after
long periods of work.
– Always use original sanding pads. Foreign pads are not suitable for the speed of the sander and may break.
– If the power tool is dropped or falls, check for damage to the machine and sanding pad. Remove the sanding pad for closer inspection. Repair
damaged parts before using again. Broken sanding pads and damaged machines can cause injuries and machine instability.
Mixed dust containing metal and sanding damp surfaces
When mixed dust containing metal (such as dust resulting from paint sanding in the automotive field) and when sanding damp surfaces, the
following measures must be observed for reasons of safety:
– Connect the machine to a suitable dust extractor.
– Regularly blow out the motor housing of the machine to remove dust deposits
Technical data
Voltage/Frequency 230-240 V / 50 Hz
Power 350W
Maximum speed 4000 - 10000/min
Sanding pad diameter 150 mm
Weight 1.75 kg
4
* The manufacturer reserves the right to make minor changes to product design and technical specifications without
prior notice unless these changes significantly affect the performance and safety of the products. The parts described /
illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's
product line with similar features and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement
work, including maintenance and special adjustments, must only be carried out by technicians of the authorized service
department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may
cause malfunctions or even serious injury or death. The manufacturer and the importer shall not be liable for injuries and
damages resulting from the use of non-conforming equipment.
WWW.NIKOLAOUTOOLS.COM