Axor Citterio 280 391511 Serie Instructions De Montage / Mode D'emploi / Garantie page 2

TEC HN IC A L IN F ORM AT IO N
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
lavatory
bidet
Hole size in mounting surface
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
INSTALL ATI ON CO N SID E RATI ON S
⁄ For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
⁄ Inspect this faucet thoroughly before installation.
Claims for shipping damage made after installation
will not be honored.
⁄ Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
⁄ The drain is suitable for most, but not all, lavatory
sinks sold in the United States and Canada.
⁄ This drain is intended for use in a sink with an
overflow. If your sink does not have an overflow, or if
this drain is too small for the hole in your sink, please
refer to the instructions included with the sink. Some
sinks include special drain installation instructions
and/or parts. Others require the use of a specialty
drain. Hansgrohe is not respnsible for the cost of a
specialty drain.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.2 GPM (4.5 L/min)
1.5 GPM (5.7 L/min)
1⅜" (36 mm)
15/8" (40 mm)
E N G L I S H
⁄ 39021XX1/39151XX1 only: This faucet does not
include a drain or a pull rod.
NOTE: The hot and cold supply hoses includ-
ed with this faucet are for use with ⅜ stops.
If your stops are a different size, purchase
adapters at your local plumbing supply store
or home center. Adapters are not available
from Hansgrohe.
⁄ Model # 39214XX1 / 39201XX1 only: The dis-
charge water temperature from a bidet fitting shall be
limited to a maximum temperature of 110ºF (43ºC)
by a water temperature limiting device conforming to
ASSE 1070.
⁄ Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.